It's Better in Abrasion Performance!

COMPARATIVE ABRASION TESTS – (20:40 TO 1)

When plunging high speed trimmer line and MACH 4® line blades directly into concrete, MACH 4® line blades outlasted round line by more than 20 to 1. BRICK, ASPHALT EDGING TESTS – (50X FARTHER) While operating at low RPM’s i.e. part throttle near 4000 RPM, four MACH 4® line blades successfully edged 50 times farther (than 2 round lines) without having to stop or experiencing harassing interruptions compared to conventional line. We ran over 850 ft. (with part throttle) while impressively edging directly against asphalt.  Under the same ground conditions, round line required a replenishment every 15 ft. on the same test track and did not produce anywhere near the MACH 4® edging quality even under very tough grass conditions.	When plunging into concrete, MACH 4® line blades outlasted round line by more than 20 to 1.
MACH 4® line blades successfully edged 50 times farther than round line	FUEL EFFICIENT - (1/2 OR MORE SAVED) LESS FUEL - LESS REFUELING Comparative tests reveal same job done with about ½ the fuel required to run conventional monofilament line. This is due to the lower speeds and the power saved by reducing drag. This benefit also reduces your refueling time. COSTS LESS – (BETTER VALUE WITH MACH 4® TRIMMING SYSTEM) SAVES TIME AND MONEY When operated as recommended, an eight pack of MACH 4® replacement line blades will likely outlast a 15 ft. pre-wound spool of conventional line. A pre-wound spool generally costs between $6-9. MACH 4® replacement lines will outlast and represent a much better value.

 WHEN LINE BLADES DO WEAR OUT AND NEED TO BE REPLACED, IT’S EASY TO RELOAD!

Depress tabs – remove cover Remove worn lines Snap in new line blades Replace cap

Back to top